Most homeowners experience toilet flushing problems. Some are our faults, while others are due to the plumbing and the minerals in the water used for flushing. There are many reasons why your toilet won’t flush. However, there are five main causes. If your toilet isn’t flushing, you can read the following information to discover the possible causes and how to fix them.
1. Toilets clogged
One of the reasons why your toilet won’t flush is because of a blockage. Most of the time, we flush things that shouldn’t go down the toilet drains. Remember that only our waste should be flushed down our toilets.
But if the worst already happened, here are some tips on how to unblock your toilet. You just need to pour a liquid drain cleaner (for toilets) into your toilet bowl and let it rest for at most fifteen minutes. The water level will drop, which means that whatever is causing the clog has moved. Use a toilet unblocker like a plunger, or a toilet auger, if the water level does not change. To remove the blockage, insert a plunger in the opening of the toilet. You can also use an auger to push the waste out and allow your toilet to flush.
2. A low water level in the toilet’s tank
A low water level in your toilet’s tank can reduce its ability to clean effectively. Your tank’s water level should be at the recommended level. The tank will have a mark that indicates the water level. This mark should be located one inch below your tank’s top overflow tube. If the water level in your tank is lower than recommended, you should check that there have been no adjustments to the water valve to reduce the flow of water into the tank. Turn on the water valve if it was not turned on.
3. Flapper Problems
The flapper is another issue that can affect the flushing power of your toilet. The flapper can be bent or curled, which could affect the flushing ability of your toilet. To ensure your toilets flush properly, make sure you inspect the rubber seal at the bottom of the tanks. The flapper is essential for flushing. It allows all water to flow into the toilet bowl after the chain lifts it up. The rubber seal prevents water from leaving your tank when the toilet isn’t in flushing mode. If you notice a problem with the toilet’s flushing, make sure to check the rubber seal. If you suspect the problem is in the rubber seal, drain the water from the tank and install a new one.
4. Poorly functioning lift chain
Your toilet may not flush properly if the flapper chain isn’t in its right place. It can cause your toilet not to flush properly if it isn’t in the right place or is loose. Make sure the flapper chain is at the right length. Adjust it if it is not. This will allow water to drain from your toilet tank.
5. Blocked inlet holes
A poorly flushing toilet can be caused by a clog in your inlet holes. They can become blocked and prevent water from passing through the toilet. To determine if the problem is in these holes, check to see if water comes out of the bowls after you flush. If water does not flow from the bowls, it is likely that there is a problem. The problem can be diagnosed by heating some white vinegar. Use a funnel to pour the liquid into the overflow tube. Let the liquid sit for at least an hour without flushing the toilet. Hard water may also cause clogging. To ensure that your toilets are clean, you should consider a water softener.
These are the most common reasons your toilet may not flush. If your toilet is not flushing, you should inspect it thoroughly. If you notice a persistent problem with your toilet flushing, call in a professional plumber to help you.
